Temperature regulating switch

Temperature regulating switch Part No. 411 963 107 A is no longer available. This switch was installed in vehicles from Chassis No. 411 2 000 001 to 412 2 100 000.

If wiring is changed as shown in this bulletin you may replace switch Part No. 411 963 107 A with Part No. 411 963 107 C (from model year 1973 - see Workshop Bulletin F of 4 September 1972).

Temperature regulating switch, installing

• find 8 point connector underneath left side of dashboard
• cut wire from temperature regulating switch terminal 58 b to light switch terminal 58. Be sure to cut wire about 4 inches from connector.
• extend cut end of wire and connect from regulating switch to 0.5 sq.mm. blue/red wire in 8 point connector T 8a
• insulate cut off end of wire to light switch
• connect temperature regulating switch terminal 31 and brown/white wire of 8 point connector T 8a with a 6 inch piece of 0.5 sq.mm. wire.

Note

When temperature regulating switch Part No. 411 963 107 C is installed it will only light up when heater is turned on. New switch will not have bright/dim operation as old switch did.